Fine Initial Alignment Procedure of the Transmission Monitor Telescope

Document #:

LIGO-E1200453-v6

Document type:

E - Engineering documents

Abstract:

"Fine" initial alignment of the TMS telescope to the ETM (as opposed to the "rough" one done under the test end) is described.

Files in Document:

• E1200453-V6-Fine initial alignment of TMS.pdf (file is not accessible)

Other Files:

• E1200453-V6-Fine initial alignment of TMS.odt (file is not accessible)
• Kiwamu's calculation about dead-reckoning the QPD1 beam position when BS wedge is sensible. (kiwamu_sensibleWedge.jpg, file is not accessible)
• When BS wedge is not sensible. (kiwamu_1.jpg, file is not accessible)

Topics:

• Installation

Authors:

• Keita Kawabe
• Matthew Evans
• Bram Slagmolen

Keywords:

TMS Transmission Montor Telescope Alignment

Notes and Changes:

Information was added about dead reckoning the beam position on QPD1 in case the worker cannot see the faint beam.

Laser Safety: Any personnel who will be working on or near the HAM1 Optics Table shall first be authorized by the local Laser Safety Officer, by training and discussion regarding setup and task, and follow the requirements detailed in LIGO-M960001, LIGO Lab Laser Safety Plan, and any site specific laser safety requirements that pertain to the work performed. The wearing of laser safety goggles and any other required personal protection equipment shall be strictly followed, as well as any special safety design/setup that prevents injury or property damages.

Related Documents:

• LIGO-T1200475: Use of Green Beam for IR QPD Path on Transmission Monitor Telescope

Referenced by:

• LIGO-T1100304: TMS ASSEMBLY and ALIGNMENT DOCUMENTATION
• LIGO-E1200166: aLIGO, ISC, TransMon