Initial Alignment Procedure -WBSC6
- Document #:
- LIGO-E1101071-v3
- Document type:
- E - Engineering documents
Other Versions:
| LIGO-E1101071-v5
05 Jun 2014, 13:45 |
- Abstract:
- This is the procedure for the initial alignment of the Hanford BSC6. This document describes the necessary equipment and procedures for setting the initial positions and the angular alignments of the principal optics both for the cartridge installation on the test stand and the later installation of the cartridge into the chamber.
- Files in Document:
-
- E1101071-v3 WBSC6 initial alignment procedure.pdf (file is not accessible)
- Other Files:
- E1101071-v3 WBSC6 initial alignment procedure - as built.pdf (file is not accessible)
- E1101071-v3 WBSC6 initial alignment procedure.docx (file is not accessible)
- Topics:
- Notes and Changes:
- still missing:
- height references for the Y-end station
- would be good to use images of the new retro-reflector mount to illustrate the procedure (also need to note the D# for this new mount)
- missing reference to the SUS procedure for vertical position adjustment
- need confirmation that the allowable decenter error for TMS is +/- 6 mm vertically & horizontally and mechanical registration is good enough for longitudinal position (say ~+/- 3 mm)
- need better definition/review from ISC on alignment procedure (e.g. specific sensor references) for the TMS
-
- Related Documents:
- LIGO-E1100690: Initial Alignment Procedure - WBSC8 As Built
- LIGO-E1100782: Initial Alignment Procedure -LHAM1
- LIGO-E1100783: Initial Alignment Procedure - LHAM2 and LHAM3 As Built
- LIGO-E1100784: Initial Alignment Procedure - LHAM4 and LHAM5 As Built
- LIGO-E1101071: Initial Alignment Procedure - WBSC6 As Built
- LIGO-E1101072: Initial Alignment Procedure -LHAM6
- LIGO-E1200393: Initial Alignment Procedure - LBSC3 As Built
- LIGO-E1200795: Initial Alignment Procedure - WBSC2 As Built
- LIGO-E1200956: Initial Alignment Procedure - LBSC4 As Built
- LIGO-E1200957: Initial Alignment Procedure - LBSC5 As Built