aLIGO BS/FM Prism bonding support cylinder

Document #:

LIGO-D1002151-v3

Document type:

D - Drawings

Abstract:

PTFE cylinder used in two places on the bonding fixture assembly to ensure a soft contact between the jig and the barrel of the respective mass during set-up and bonding of prisms.

Files in Document:

• D1002151-v3 Bonding Jig Support Cylinder.pdf (file is not accessible)

Other Files:

• D1002151_aLIGO_BSFM_PRISM_BONDING_SUPPORT_CYLINDER.STEP (file is not accessible)

ICS/JIRA Record:

• ICS_LINK

Topics:

• Installation
• Suspensions

Authors:

• Marielle van Veggel
• Russell Jones
• Calum Torrie
• Liam Cunningham

Keywords:

aLIGO suspensions BS/FM beamsplitter folding mirror prism bonding

Notes and Changes:

-v3 details the as-built configuration changes at LLO and LHO.

The Teflon cylinders, D1002151, must fit into the opening of the baseplate, D1002149,https://dcc.ligo.org/LIGO-D1002149

The baseplate does not have a tolerance on most of the dimensions. They are typically zero place decimals, like 7mm, 66mm, and such. The tolerance block for the drawing is for .X +/- 0.1mm. So, even if the part were made perfectly, at a 66mm opening, the top end of the cylinder tolerance is 66mm. The baseplate should have a tolerance block of XX +/- X.1 and the cylinders should be made to 65mm +/- 0.1mm

Referenced by:

• LIGO-D1002147-v1: aLIGO BS/FM Prism bonding jig