1) DOCUMENT CHANGE NOTICE (DCN):
DCN No. E1000839-v1


2) INFORMATION:
DOCUMENT No.	TITLE
D1002211-v3:	aLIGO TMS FLEXIBLE SEC MIRROR MT.
D1000071-v2:	TRANSMON_TELE_END_PLATE_ENTRY_3_TUBE
C1002521-v1:	TDM - Delta High-Tech, Drawing D1000071-v2
C1002522-v1:	TDM - Delta High-Tech, Drawing D1002211-v3


3) CHANGE DESCRIPTION (FROM / TO):
D1002211-v3:
 SHEET 2, ZONE B-8:
 One 10-32 tapped hole in the view was showing dashed lines representing threads, while an adjacent 10-32 tapped hole was without
 dashed lines. Both holes show dashed lines representing threads this revision.

 SHEET 3, ZONE C-5:
 One 10-32 tapped hole in the part (right-center in view) was showing a dashed circle representing threads, while another 10-32 tapped
 hole (near top in view) was without a dashed circle. Both holes show dashed circles representing threads this revision. Also, a
 dashed circle representing the coaxial .234 diameter hole to the far side of the upper 10-32 tapped hole is added this revision.

D1000071-v2:
 SHEET 1:
   ZONE B-6:
   SECTION A-A view moved from SHEET 1 to SHEET 3.

   ZONE A-5:
   DIAMETER Dim 8.50 THRU -WAS- 7.50 THRU.

 SHEET 2:
   ZONE A-3:
   Bolt circle diameter -FROM- 8.250 -TO- 9.250.
   Bolt circle diameter -FROM- 9.375 -TO- 10.375.

 SHEET 3:
   SECTION A-A:
   Dim .122-.142   -WAS-   .08-.10.
   Added .012-.020 material reduction from left end of part in view to .12 right of flexure feature.


4) REASON FOR CHANGE:
D1002211-v3:
The above stated non-consistencies of the previous revision caused confusion to the first article part vendor.

D1000071-v2:
Necessary corrections & improvements to form fit & function of the part.


5) SIGNATURES REQUESTED:
Ken Mailand
Calum Torrie
Dennis Coyne


6) DCN DISTRIBUTION:
Ken Mailand
Calum Torrie
Dennis Coyne


7) NOTES: